Toshiba CTX100-S - Manual Dialing to Connect to the CTX Modem

Installation
Step 4: Establish Communication with Strata CTX
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 3-17
Installation
Manual Dialing to Connect to the CTX Modem
If the CTX WinAdmin application is running in Windows operating systems and you want to dial in to
CTX manually with a bridged telephone (operator-assisted dialing) instead of having CTX WinAdmin dial
the phone number, perform the following:
Step 1: Connect to the CTX modem with manual dialing
1. Make sure that your dialing phone is bridge connected to your modem’s “Line” jack.
2. Set up your modem dialing for Windows Operator-Assisted Dialing by opening Network Connections
in the Control Panel.
3. On the Advanced menu at the top of the screen, select Operator-Assisted Dialing, then Exit.
Step 2: Make an operator-assisted call
1. Bring up the CTX
WinAdmin Connection
page (shown right).
2. Enter the CTX
Community Name (or
select a CTX Host
Name) and check Use
Dial-Up.
3. Enter a comma or a
phone number in this
box.
4. Click Connect Now.
5. Go off-hook with the
bridge telephone and
dial the CTX site
number.
6. When the call is
answered by a person or
Auto Attendant, ask to
be transfered to the CTX
modem number #19.
The called party should
then hang up.
7016
You must enter
a comma or a
phone number.