Toshiba CTX100-S - Make Busy Control

Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 11/03 13-107
Telephone Button
Programming
Note Before running this program, make sure the SmartMedia card is properly formatted. See “Format/
Unmount SmartMedia” on page 13-103 for more details.
1. Press
)% to enter your Backup choice. Press the 6FUROO or 3DJH button to view your selection
options.
2. Press
. )% and )% should blink green.
3. Press
+ROG to execute. Press +ROG again to Cancel. This program stops running if you exit
programming mode from your telephone.
Make Busy Control
When an error occurs in hardware resources used for a station or a line fails, this feature makes them busy.
The station or line PCB can be disabled temporarily to perform maintenance or parts replacements as well.
This program is only available in the telephone button programming mode.
Program Number(s): 912
Prerequisite Program:
Format SmartMedia Card
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter  and press +ROG.
At the CABINET= prompt enter the Shelf number.
Total Blocks
02 View total blocks to be updated (total blocks
will vary depending on software versions).
0~65536 (CTX670)
0~128 (CTX100)
default = 0
n/a
Copied Blocks 03 View number of blocks copied. 0~65536 (CTX670)
0~128 (CTX100)
default = 0
n/a
Active Side Status 04 Backup Type Display 1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
Stand by Side Status
05 Stand by Backup Type 1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
Active Side Number
06 Active Side Number. 0 or 1
default = 0
ACT SIDE=
Status
07 View Backup Status. 1:Idle
2:Running
3:Success
4:Error
1:Idle
2:Running
3:Success
4:Error
FB Name FB Summary Value LCD Prompt