Toshiba CTX100-S - Page 422

Telephone Button Programming
900 Series Programs
13-108 Strata CTX Programming - Part 3: Telephone Button Programming 11/03
Note The Shelf number is entered in “XX” format where Shelf is a two digit value from 01~07
corresponding to the Strata CTX Cabinet number. See “Program Button LEDs” below for a
description of the LED display.
1. Press
)%~)% to enter your Make Busy selection for the appropriate Slot in the Cabinet entered in
Access Sequence above.
Note The slot to which your programming phone is connected can not be set to Make Busy.
2. Press
+ROG to execute.
3. Press
+ROG again to return to CABINET= prompt.
4. Press
+ROG to return to the PROG= prompt.
5. Enter another program number to continue programming or press
+ROG again to exit programming
mode.
Program Button LEDs
The LED blink pattern indicates the following:
• Red continuous blinking – PCB experienced a Make Busy status error.
• Red continuous illumination – PCB Make Busy Status mode is on.
• Green continuous blinking – PCB Make Busy Status mode is stand by.
• Green intermittent blinking – PCB Make Busy Status mode is idle.
FB Name FB Summary Value
Equipment 00 Enter Cabinet Number 01~07 (value=xx)
Slot #1
01
Enter  or 
1: Set make busy
2: Clear make busy
Slot #2
02
Slot #3
03
Slot #4
04
Slot #5
05
Slot #6
06
Slot #7
07
Slot #8
08
Slot #9
09
Slot #10
10