Toshiba CTX100-S - PAD Group Assignment

System
PAD Table
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 4-23
System
108 PAD Group Assignment
Prerequisite Program: None
You can enter up to 32 additional devices to the PAD table to deal with exceptions to the default table.
Table 4-2 PAD Table
PAD Device Number 1 2 3 4 5 6 7 8 9 10 101 102
:
131 132
PAD Device Number
Receiver (Listener)
Analog Telephone DKT Analog Trunk T1 Trunk ISDN Station ISDN Trunk CONF Bridge Music Source Ext. Paging IPT PAD Group 1 PAD Group 2
:
PAD Group 31 PAD Group 32
Sender (Speaker)
1 Analog Telephone 0 0 0 6 6 6 X
1
-0000
2DKT 0006660-0000
3 Analog Trunk 0 0 6 6 6 6 X
1
-6000
4T1 Trunk 6660000-6300
5ISDN Station 6660000-6300
6ISDN Trunk 6660000-6300
7 Conference Bridge (0) (0) (0) (0) (0) (0) (0) (0) (0) 0 0 0
8Music Source 000000000000
9Ext. Paging 006666000000
10IPT -60-600 0-6--600 0
101 PAD Group 1
2
0 0 -3 -3 -3 -3 -3 -3 -3 0 0 0
102 PAD Group 2
3
333333333330
::
131 PAD Group 31
132 PAD Group 32
Notes
1. “X” data set for PAD Conference table Assignment
2. For IP QSIG only. The default values for PAD Group 1 is 0dB. dB is the value for attenuation level.
3. For PRI QSIG only.
FIELD DESCRIPTION
00 PAD Group Device Type Enter the Device Type from Table 4-3 below.
Possible values: Up to 6 digits.
x = Device Type; yyyyy = Device number
(default = no value)
01 PAD Group Number Enter the PAD Group Number
Possible values: 0~6 (CTX100), 0~6 (CTX100 Basic), 0~32 (CTX670 Exp.),
(default = 0)