System Error Codes
Station Programming Error Codes
B-10 Strata CTX Programming - Part 4: Appendices 11/03
213
82
The additional information assigned to the Feature Button is
invalid.
82 - 120 The line number entered does not exist.
96
110
130
140
The allowable number of GCO, POOL or PhDn has been
exceeded.
98 -
The quantity of Flexible buttons programmed exceeds the
system’s capacity.
214
33
)%a)%
The equipment number entered is out of the range.
49
The designated circuit is already in use.
50
Multiple DSSs cannot be assigned to the same Shelf/Slot/
Circuit.
51
The entered DN does not exist in the system (the entered
value conflicts with an existing extension number or
numbering plan).
52
The entered value conflicts with an existing numbering plan.
80
)%
The designated Prime DN does not exist in the system.
80
)%a)%
The designated PCB and extension combination is not
allowed.
96
)%a)%
The number of DSS consoles entered exceeds the system’s
capacity.
98
The number of DSS buttons entered exceeds the system’s
capacity. This error can occur with PB1~PB8
215 33
The add-on module number is out of the range.
33
)%
100
110
120
130
140
The sub-parameters for Key Number field must be assigned.
33 - 120
The line number entered is out of range for the system’s
capacity.
33 - 130 The GCO key group/index entered is out of the range.
33 - 140 The POOL group entered is out of the range.
33 - 530 The BGM number entered is out of the range.
33 - 540 The door lock number entered is out of the range.
33 - 900 The application number entered is out of the range.
48
Essential sub-parameter values must be entered.
49
)%
110
Two or more PhDNs with the same value are registered to
one extension.
Program Code FB
Sub-
parameter
Error Descriptions
To Next Page
Loading...
