To Next Page

To Previous Page

ADJUSTMENT

3 - 49

3.3.4 Adjustment of faint text

The faint text can be improved in the following codes.

(1) While pressing [0] and [5] simultaneously, turn the power ON.

(2) Key in the codes to be adjusted and press the [START] button.

(3) Key in the adjustment value. (To correct the value once keyed in, press the [CLEAR] button.)

(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment

goes back to the ready state.

(5) For resetting the value, repeat step (2) to (4).

(6) Let the equipment restart and perform the printing job.

(7) If the desired image has not been attained, repeat step (1) to (6).

3.3.5 Upper limit value at Toner Saving Mode

The upper limit value is adjusted at the Toner Saving Mode.

The procedure is the same as that of  P.3-46 "3.3.2 Gamma balance adjustment (Black Mode)".

Black mode Color mode

Remarks

PS PCL XPS PS PCL XPS

7340 7341 7342 8130 8131 8132 When the small characters or fine lines in a halftone

image are faint, they can be improved by increasing

the value to raise the density level.

Acceptable values: 0 to 8 (Default: 0)

Black mode Color mode

Remarks

PS PCL XPS PS PCL XPS

664-0 664-1 664-2 1055-0 1055-1 1055-2 The smaller the value is, the lighter the density of

image becomes.

Acceptable values: 0 to 255

Toshiba e-studio2330c Service Handbook

Other manuals for Toshiba e-studio2330c