e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
BACKUP FUNCTION
4 - 20
[I] Check actuation of data encryption function setting
Check if the data encryption function is in operation.
• Press the [USER FUNCTION] button on the control panel. If a key-shaped icon is displayed at the
top right of the screen, the data encryption function is in operation.
Fig. 4-14
4.2.4 Procedure for disabling data encryption function
The basic procedure is the same as the one for enabling this function. To disable it, set “0 (Invalid)” in
the code 08-9379 at step P.4-17 "[D] Enable data encryption function".
4.2.5 Procedure for discarding HDD when data encryption function is
enabled
Set the data encryption function disabled following the procedure shown in P.4-20 "4.2.4 Procedure
for disabling data encryption function". Then perform the code 08-1426 (Forcible HDD data clearing) to
completely erase the data in the HDD.
To Next Page
Loading...
Need help?
General
