e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 16
(3) Lift up the CIS unit [1], disconnect 1
connector [2] on the bottom of the CIS unit,
and then take off the CIS unit.
Notes:
1. Take care not to contaminate the CIS unit
surface with fingerprints, dust or such.
2. Do not place the removed CIS unit upside
down.
3. Be sure to perform “05-3219” with the
platen cover or the RADF closed after
replacing the CIS unit.
4. Be sure to unlock the connector before
disconnecting it.
5. If the spring comes off, it is attached black
spring [3] to the front side, and brown
spring [4] to the rear side.
Fig. 4-40
6. When installing the CIS unit, be sure to
pass the flat harness through the harness
holder of the CIS case.
Fig. 4-41
7. After installing the CIS unit, move it to the
left side of the equipment.
Fig. 4-42
[
1
]
[
4
]
[
3
]
[
2
]
To Next Page
Loading...
