e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
EXTERNAL COUNTERS
12 - 4
12.3 Notices
12.3.1 Setting code
Each signal will be enabled by configuring the setting code “08-9016” (Counter installed externally).
08-9016
0: No external counter (Default)
1: Coin controller installed
12.3.2 Setting value change and restrictions when using the coin
controller
1. Setting value
- 08-9016 (Counter installed externally): Set to “1” (Coin controller).
- 08-9017 (Setting for counter installed externally): Select “1” (Copy) for the job to count up.
2. Restrictions
For 08-6011 (Definition of large-sized paper), set to “0” when A3, LD and CUSTOM are specified as
the large size, and set to “1” when B4, LG, FOLIO, COMP, 8K and 13"LG are specified as the large
size in addition to A3, LD and CUSTOM.
12.3.3 Installation of External Counter
It is not allowed to install more than one external counter. Physically, the multiple external counters
cannot be installed together since the output signals are used in common.
12.3.4 Restrictions when installing the coin controller
If the department management (08-9120 / 0: Disabled, 1: Enabled) of the 08 setting code is enabled, its
screen will appear prior to others. Therefore, be sure not to enable the department management when
the coin controller is installed.
To Next Page
Loading...
