Toshiba e-studio2507 - Exit Sensor (S3)

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 91
4.8.11 Exit sensor (S3)
(1) Take off the fuser unit cover/guide.
 P. 4-78 "4.8.2 Fuser unit cover/Fuser unit
guide"
(2) Take off the guide [1].
Fig. 4-241
(3) Remove the cover [2].
(4) Take off the actuator [3] and spring [4].
Fig. 4-242
Notes:
When installing the actuator, hook the spring
as shown in the figure.
Fig. 4-243
[1]
[3]
[4]
[2]