e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 72
8.4.6 Poor fusing
Fig.8-8
Defective area Step Check items Prescription
Heater electric power 1 Check if the connector contacts
properly.
Correct it.
2 Is the heater shorted or broken? Replace the heater.
Pressure between fuser
roller and pressure roller
3 Are the pressure springs working
properly?
Check and adjust the pressure
springs.
Fuser roller temperature 4 Is the temperature of the fuser roller
normal?
Check the setting and correct it.
08-2010, 2009, 2100
Developer material/Toner 5 Using the specified developer
material and toner?
Use the specified developer material
and toner.
Paper 6 Is the paper in the drawer damp? Avoid storing paper in damp place.
7 Is the paper type corresponding to its
mode?
Use the proper type of paper or
select the proper mode.
8 Is the setting temperature of the fuser
roller in each paper type normal?
Check the setting and correct it.
(08-2049, 2050, 2051, 2194)
9 Using the recommended paper? Use the recommended paper.
Feeding direction
To Next Page
Loading...
