6
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
6 - 27
6.4.6 Adjustment of image density
The image density level can be set at the following codes.
< Adjustment Mode (05) >
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR/STOP] button.)
(5) Press the [OK] button to store the value in memory. The equipment goes back to the test mode A
screen.
(6) For resetting the value, repeat step (2) to (5).
(7) Press the [SETTINGS] button and then select an original mode. Then press the [START] button
to perform test copying.
(8) If the desired image density has not been attained, repeat step (2) to (7).
Code
BackGround
Erase
Item to be
adjusted
Remarks
Text/photo Text Photo
7218-0 to 4 7219-0 to 4 7220-0 to 4 7223-0 to 4 Adjustment of
image density
When the value is decreased, text
becomes lighter.
Acceptable values: 0 to 10
Notes:
1. Set not to reverse the large
and small number of the
setting value corresponding
to the sub code.
Ex.) When the image density
level for 7218-0, 7218-1,
7218-2, 7218-3, and 7218-4
is assumed to be “A”, “B”,
“C”, “D”, and “E”
respectively, they should
have the following
correlation:
2.
Remember that the image
specifications and life span
of the replacing parts may
not meet the standard when
the setting value is changed
from the default value.
B C D E
To Next Page
Loading...
