Toshiba e-studio2507 - Scanner Related Adjustment

6
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
6 - 15
6.3.5 Scanner related adjustment
[A] Reproduction ratio adjustment of the primary scanning direction
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON  (Adjustment Mode)
(2) Place a ruler on the original glass (along the direction from the rear to the front of the equipment).
(3) [SETTINGS]  [USER FUNCTIONS]  Select [DRAWER]  Select [DRAWER1]
 Set the paper size to A3/LD.  [OK]  Set A3/LD for the paper in upper drawer.
(4) [CANCEL]  [CANCEL]  Select the upper drawer by pressing [DRAWER].  Press [START]
to make copies.
(5) Measure the distance A from 10 mm to 270 mm of the copied image of the ruler.
(6) Check if the distance A is within the range of 260±0.5 mm.
(7) If not, use the following procedure to change values and measure the distance A again.
[SETTINGS]  (Key in the code [4000])  [START]
 (Key in a value (acceptable values: 0 to 255))
 [OK] (Stored in memory)
 [SETTINGS]  Select the upper drawer by pressing [DRAWER].  Press [START] to make
copies.
* The larger the adjustment value is, the higher the reproduction ratio and the longer the
distance A become (approx. 0.15 mm/step).
Fig.6-9
50 100 150 200 250
A
Feeding direction
Copied image of the ruler