Toshiba e-studio2507 - Separation Finger

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 83
4.8.6 Separation finger
(5) Place the fuser unit facing the original
direction, take off the base unit [1].
Fig. 4-220
Notes:
When installing the base unit, make sure that
the sheets [1] are attached as references of
the rib [2] and boss [3].
Fig. 4-221
(1) Take off the base unit.
 P. 4-82 "4.8.5 Base unit"
(2) Pull out the separation finger [1] from the
groove.
(3) Remove the spring [2].
Fig. 4-222
[1]
[2] [2]
[3]
[1]
[2]
[1]