Toshiba e-studio2507 - ADU Clutch (CLT4)

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 126
4.11.5 ADU clutch (CLT4)
4.11.6 ADU fan duct unit
(1) Remove 1 connector [1] and 2 screws and
then remove the “ADU clutch (CLT4)” [2].
Notes:
Be sure the bush is securely in the hole
during installation.
Fig. 4-334
(1) Remove the inner tray.
 P. 4-2 "4.1.3 Inner tray"
(2) Remove the ADU fan duct [1].
Fig. 4-335
(3) Remove 1 connector [2] and remove the
ADU fan duct unit [3].
Fig. 4-336
[2]
[1]
[3]
[2]