e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 82
8.4.15 Poor image transfer
Fig.8-17
Defective area Step Check items Prescription
Paper 1 Is the paper in the drawer curled? Reinsert the paper with the reverse
side up or change the paper.
2 Is the paper in the drawer damp? Avoid storing paper in damp place.
3 Is the paper type corresponding to its
mode?
Select the proper mode.
4 Using the recommended paper? Use the recommended paper.
Transfer roller unit 5 Is the transfer roller contacting with
the drum? Are the charger pushing-
spring and the transfer roller
pressure spring installed properly?
Check them and reinstall if required.
Registration roller 6 Is there any abnormality related to
the registration roller or with the roller
itself?
Clean the roller if it is dirty. Securely
attach the springs if they are
detached. Replace the clutch if it is
defective. Adjust the rotation speed
of the roller.
High-voltage transformer
(Transfer roller unit)
7 Is the high-voltage transformer
output defective?
Adjust the output, or replace the
transformer.
Feeding direction
To Next Page
Loading...
