Toshiba e-studio2507

To Next Page

To Previous Page

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A

SELF-DIAGNOSIS MODES

5 - 30

5.10.3 Functions

[A] Set Serial Number

When replacing MAIN board, select this to set the serial number of the equipment since it must be done

in advance of recovery from flash memory backup data.

• Clear flash memory first and then set the serial number in this mode.

[B] Clear SRAM

Select this to clear all flash memory data when replacing the main board flash memory.

• Replace the MAIN board and then clear the flash memory data.

• After clearing the flash memory data, initialize flash memory following its replacement procedure.

Remarks:

Notes:

When the memory has been cleared in the Assist Mode (6C), check the items below and change

the value of the following codes accordingly:

• 08-3134 (Scan motor gear) <20L/23L/25L/20H/23H/25H only>

0: One-gear

1: Two-gear

• 08-9063 (Installation of the fax function)

0: Not installed

1: Installed

Though the menu includes an "SRAM" item, the machine

is actually equipped with Flash memory, not SRAM.

SRAMCLEAR

SETSERIALNUMBER

CLEARSRAM

Toshiba e-studio2507 - Functions