Toshiba e-studio2507 - Adjustment of Skew

To Next Page

To Previous Page

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A

SETTING / ADJUSTMENT

6 - 42

6.10.2 Adjustment of Skew

Notes:

• Check if the image adjustment for the equipment has been performed properly before this

adjustment of the RADF.

(See the Service Manual of the applicable equipment.)

Also, the tray volume has been adjusted properly.

• After this adjustment is performed, be sure to carry out the leading edge position, horizontal

position and copy ratio adjustments.

• The skew volume sometimes does not become "0" even if this adjustment mechanism using

the hinge is adopted.

Moreover, a problem such as damage to parts may occur if an attempt to adjust the volume is

made by exceeding the recommended adjustment width of the hinge.

[A] Checking

Check the image using the chart (original) with vertical and horizontal lines in the following procedure.

Fig.6-26

(1) Place the chart provided as an original with its face up on the original tray of the RADF and press

the [START] button.

(2) Superimpose the chart on the copy and check the inclination of the copy image.

[B] Adjustment

(1) Turn the screw shown in the figure below to adjust the skew.

Fig.6-27

Other manuals for Toshiba e-studio2507