Toshiba e-studio2507 - Paper Feed Unit (PFU)

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 135
4.13.2 Paper feed unit (PFU)
(1) Turn off the main power switch and unplug
the power cable from the outlet.
(2) Remove the drawer.
(3) Take off the rear cover.
 P. 4-6 "4.1.10 Rear cover <23LA/23LM/
28LM/23HA/28HA>"
(4) Remove 3 screws and remove the PFU gear
unit [1].
Fig. 4-361
(5) Release 2 clamps [2] and disconnect 1
connector [4] from the MAIN board [3].
(6) Disconnect 1 connector [5].
(7) Remove 1 screw and the ground wire [6].
Fig. 4-362
(8) Remove the upper drawer and the lower
drawer (PFU drawer).
(9) Remove 1 screw and remove 1 front left
fixing bracket [7].
Fig. 4-363
[1]
[5]
[6]
[3]
[4]
[2]
[7]