e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 28
7.4.12 PFP
Fig. 7-24
* n1. Separation roller (upper/lower)
The replacement cycle of the parts in the feeding section equals to the number of sheets
fed from each paper source.
Notes:
Apply the appropriate amount of the grease as specified in the right figure.
Fig. 7-25
Item to inspect Cleaning Coating
Replace every 1K
copies
Parts list
<P-I>
Remarks
N1 Pickup roller (upper/lower) A 90 5-43
N2 Feed roller (upper/lower) A 90 5-39
N3 Separation roller (upper/
lower)
AAV 90 5-42*n1
N4 Drive gears (tooth face) W
Apply the grease on the
inside entirely
Separation roller
To Next Page
Loading...
