e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 20
[E510] ADU stack jam (paper not reaching the ADU transfer sensor
Classification Error content
Paper transport jam (ADU section) Jam not reaching the ADU transfer sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the right cover. Is
there any paper in front of
the ADU transfer sensor?
Yes Remove the paper.
No
2
2
Is the ADU transfer sensor
working? (Perform the
input check in the test
mode: 03-[1]/[C])
Yes
3
No • Check if the connector of the ADU transfer
sensor is disconnected.
• Check if the connector CN17 on the MAIN
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the
MAIN board are short circuited or open
circuited.
• Replace the ADU transfer sensor.
• Replace the MAIN board.
3
Is the exit motor (rotating
in reverse) working?
(Perform the output check
in the test mode: 03-121/
171)
Yes
4
No • Check if the connector of the exit motor is
disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Replace the exit motor.
• Replace the MAIN board.
4
ADU • Check the rollers in the ADU and the exit
roller of the equipment. Replace them if
they are worn out.
Parts to be replaced Remark
ADU transfer sensor
MAIN board
Exit motor
ADU exit sensor
Rollers in the ADU
Exit roller
To Next Page
Loading...
