8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 29
[E140] 2nd drawer misfeeding
Classification Error content
Paper misfeeding Jam not reaching the registration sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the feed cover. Is
there any paper on the
transport path?
Yes Remove the paper.
No
2
2
Is the 2nd drawer feed
clutch working?
(Perform the output check
in the test mode: 03-202)
Yes
3
No • Check if the connector of the 2nddrawer
feed clutch is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN27
23LA/23LM/28LM/23HA/28HA: CN16
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the 2nd drawer feed clutch.
• Replace the MAIN board.
3
2nd drawer feed roller
Separation roller
• Check the drawer feed roller and separation
roller.
Replace them if they are worn out.
Parts to be replaced Remark
MAIN board
Lower drawer feed clutch
Lower drawer feed roller
Separation roller
To Next Page
Loading...
