8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 43
[E725] Stop jam at the read sensor
[E726] Jam not reaching the Original intermediate transport sensor
Classification Error item
RADF jam Stop jam at the read sensor
Proce
dure
Check item Measures
1
Transport roller-2 Clean the transport roller if it is stained.
2
Read sensor • Sensor check (Perform the input check: 03-[8]/[G])
• Connector check
• Harness check
3
RADF board • Board check
• Connector check (PA4)
• Harness check
Replace parts Remarks
Read sensor
RADF board
Transport roller-2 Replace it if it is worn out.
Classification Error content
RADF jam Stop jam at the original intermediate transport sensor
Check item Measures
Exit/reverse roller Clean the exit/reverse roller if it is stained.
Original intermediate transport
sensor
• Sensor check (Perform the input check: 03-[8]/[E])
• Connector check
• Harness check
RADF board • Board check
• Connector check (PA4)
• Harness check
Parts to be replaced Remark
Original intermediate transport
sensor
RADF board
Exit/reverse roller Replace it if it is worn out.
To Next Page
Loading...
