© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
FIRMWARE UPDATING
11 - 5
11
(3) Connect the USB device [1] to the USB port [2].
Fig.11-4
(4) Turn the power ON while pressing the [4] and [9] buttons simultaneously.
(5) Enter the password, and then press the [OK] button.
(If the Enter Password is blank, this step is unnecessary.)
(6) Select “SYSTEM FW, ENGINE FW, FAX FW or ALL”, and then press the [OK] button.
Update starts. This will change to “COMPLETED” when the update is completed.
[1]
[2]
To Next Page
Loading...
