3
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
OUTLINE OF THE MACHINE
3 - 27
(D) Replace the toner cartridge
(E) Developer unit not installed properly
(F) Call for service
Check the error code displayed on the control panel when “Call for service” appears, and deal with
the abnormality referring to the error code table.
P. 8-7 "8.2 Error Code List"
• Toner supply cover is opened during copying
Paper jam (E410)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the feeding starts.
Paper jam (E120, E130 and E210)
• During paper feeding from ADU:
Registration sensor is not turned ON in a fixed period of time after the ADU motor is turned ON.
Paper jam (E110)
• During paper transporting from ADU:
ADU entrance/exit sensors do not detect the paper at the fixed timing
Paper jam (E510)
• Toner density becomes low
Auto-toner sensor detects the absence of the toner
Control circuit Displays the message: the copying operation disabled
Solution: Open the toner supply cover and replace the toner cartridge with a new one.
Toner is supplied copying operation enabled.
• Disconnection of the connectors of the developer unit
“Set process unit” is displayed.
[START] button disabled.
Solution: Connect the connectors of the developer unit and close the right cover.
To Next Page
Loading...
