e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
APPENDIX
6
Ver08
13-1 to 13-2 The symbol names have been added.
Chapter 14 SELF-DIAGNOSIS CODE<20L/23L/25L/20H/23H/25H>
The contents of 08-4016-0 and 08-4016-1 has been changed.
SELF-DIAGNOSIS CODE<23LA/23HA/28HA>
08-3754 have been added.
The default value of 08-3975-0, 08-3975-1 has been changed.
The procedur of 08-3989-0, 08-3989-1 has been changed.
The contents of 08-9216 have been changed.
Ver08 <2015.08.17>
Page Contents
Cover Model names have been added.
General
precautions
Notes have been added.
1-1 "1.3 Main Features of 23LA/23HA/28HA" has been added.
2-1 to 2-7 Specifications for the new models have been added.
2-8 New accessories have been added.
2-9 New options have been added.
2-12 to 2-13 System list for the new models have been added.
2-14 Supplies for the new models have been added.
3-2 to 3-4 A sectional view for the new models has been added.
3-5 to 3-13 Electric parts for the new models have been added.
3-18 to 3-19 New model names have been added.
3-29 to 3-30 An illustration of the control panel for the new models has been added.
3-33 New model names have been added.
3-65 An illustration of the heater control circuit for the new models has been added.
4-1 Procedures of disassembly and replacement of the left cover for the new models have
been added.
4-6 Procedures of disassembly and replacement of the rear cover for the new models have
been added.
4-13 to 4-14 Procedures of disassembly and replacement of the USB cable for the new models have
been added.
4-19 to 4-20 Procedures of disassembly and replacement of the CIS case for the new models have
been added.
4-24 to 4-26 Procedures of disassembly and replacement of the scan motor (M1) for the new models
have been added.
4-27 A new model information has been added.
4-37 to 4-38 Procedures of disassembly and replacement of the bypass feed roller for the new models
have been added.
4-41 Procedures of disassembly and replacement of the drawer feed roller for the new models
have been added.
4-50 to 4-51 Procedures of disassembly and replacement of the process for the new models have been
added.
4-57 to 4-58 Procedures of disassembly and replacement of the temperature/humidity sensor (S1) for
the new models have been added.
4-62 Procedures of disassembly and replacement of the doctor blade for the new models have
been added.
4-64 to 4-65 Procedures of disassembly and replacement of the mixer for the new models have been
added.
4-66 to 4-67 Procedures of disassembly and replacement of the oil seal (front side) for the new models
have been added.
Ver09 <2015.10.30>
Page Contents
To Next Page
Loading...
