Toshiba e-STUDIO2820C - Page 449

8
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
8 - 31
(5) Remove the cover plate.
Fig. 8-27
(6) Take off the converter PC board from the logic PC board (LGC board).
Fig. 8-28
(7) Connect the 10-pin side of the harness jig for board connection to the connector (CN2) of the
converter PC board.
Fig. 8-29
Cover plate
CN2