e-STUDIO2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 32
(8) Connect the 15-pin side of the harness jig for board connection to the connector (CN15) of the
finisher control PC board.
Fig. 8-30
Notes:
• Be sure to release the connection cable from the connector (CN15) of the finisher control PC
board when the hole punch unit (MJ-6101) has been installed.
• Be careful not to short-circuit any part of the converter PC board.
(9) Connect the download jig with the jig connector (CN9) on the Finisher control board.
Fig. 8-31
(10) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
Updating starts and the LED on the download jig lights
CN15
Download jig
To Next Page
Loading...
