2 SETTING ITEMS (ADMIN)
92 Setting General Functions
3
Place the printed chart face down on the glass with the bottom toward you and the top
left aligned against the original scale on the left side, so that two black rectangular
marks are placed on the left side.
4
Press the [START] button on the control panel.
After scanning the printed chart, the following message is displayed:
[Apply Calibration Setting?]
If the chart is not properly placed, the message “Set chart correctly” is displayed on the touch panel. In this
case, return to step 3 and realign the chart.
5
Press [YES] to apply the calibration setting, or [NO] to cancel it.
To Next Page
Loading...
