Toshiba E-STUDIO520 - Page 229

10
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 PROCESS RELATED SECTION
10 - 13
[D] Drum surface potential sensor (S13)
(1) Take off the cleaner unit.
( P.11-7 "[A] Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the sensor bracket.
Fig.10-18
(3) Disconnect 1 connector, remove 1 screw,
and then take off the surface potential sensor
(detection section).
Fig.10-19
(4) Disconnect 1 connector, release 4 lock sup-
ports, and then take off the surface potential
sensor (board section).
Note:
The drum surface potential sensor consists
of the detection section and the board sec-
tion as a set.
Fig.10-20
Sensor braket
Screw
Connector
Screw
Drum surface potential sensor
(
board section
)
Locking support
Locking support
Drum surface potential sensor
(
detection section
)