e-STUDIO520/600/720/850 DRUM/CLEANER UNIT March 2005 © TOSHIBA TEC
11 - 8
(6) Take out the drum upward.
Fig.11-9
(7) Remove 3 screws to take off the flange on
the front side.
(8) Pull out the drum upward.
Fig.11-10
<<Precaution when installing the drum shaft>>
• Make sure that the gap plate is not caught
with the drum shaft.
• Be sure to install the drum shaft and
cleaner frame without a gap.
• No foreign matter must be attached on
the cleaner stay.
Fig.11-11
Screw
Screw
Cleaner stay
Gap plate
No gap
To Next Page
Loading...
