e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF) March 2005 © TOSHIBA TEC
16 - 10
6) Start of 2nd original scanning
Scanning begins after receiving the original transport signal from the engine. At the same time, the
original stop signal is reset. Then the read motor (M36) starts to rotate forward and the large original
exit motor (M39) starts to rotate in reverse.
The SCN-SCR turns ON when the leading edge of the original has reached the scanning section.
When the trailing edge of 1st original has proceeded a specified distance after passing the 3rd roller,
the large original exit motor (M39) starts to accelerate.
Fig.16-16
When the leading edge of the original has been transported to the intermediate transport section
and come to a specified distance before the intermediate transport roller, The large original exit
motor (M39) starts to rotate in reverse.
Fig.16-17
The SCN-SCR turns OFF when the leading edge of the original has reached the scanning section.
When the trailing edge of the original has proceeded a specified distance after passing the 3rd roller,
the large original exit motor (M39) starts to accelerate.
Fig.16-18
To Next Page
Loading...
