16
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
16 - 11
7) After the original trailing edge has passed the 3rd roller
When the leading edge of the original has come to a specified distance before the small original exit
roller, the small original exit motor (M40) starts to rotate forward.
Fig.16-19
When the original intermediate transport sensor (S70) detects the trailing edge of 1st original, the
large original exit motor (M39) stops rotating unless the leading edge of 2nd original has come to a
given place. If it has, the large original exit motor (M39) slows down to the speed of scanning.
When the trailing edge of the original has come to a specified distance before the small original exit
roller, the small original exit motor (M40) starts to slow down.
Fig.16-20
When the original has proceeded a specified distance after the small original exit sensor (S67) had
detected the trailing edge of the original, the small original exit motor (M40) stops rotating. Then the
operation ends after 2nd original has been discharged.
Fig.16-21
To Next Page
Loading...
