Toshiba e-studio905 - Page 100

Paper Size: Tray 7 (with the optional Multi Bypass Tray and Wide LCT)
• The Tray 7 on both of the main and sub-machines are used only for the cover sheet and the
designation sheet.
Paper Size: Interposer Upper and Lower Tray (With the Optional Cover Interposer Tray CI5010)
• The main and sub-machines follow their respective set values.
• In connect copy, only the paper tray corresponding to the paper size, orientation, and type that
are set in common on the main and sub-machines can be used. To make the most of the connect
copy function, it is advisable that you make the same paper settings on both the main and sub-
machines.
Paper Size: Interposer Upper and Lower Tray (With the optional Cover Interposer Tray Type
GB5000)
• The main and sub-machines follow their respective set values.
• In connect copy, only the paper tray corresponding to the paper size, orientation, and type that
are set in common on the main and sub-machines can be used. To make the most of the connect
copy function, it is advisable that you make the same paper settings on both the main and sub-
machines.
Paper Type: Tray 1
• The main and sub-machines follow their respective set values.
• In connect copy, only the paper tray corresponding to the paper size, orientation, and type that
are set in common on the main and sub-machines can be used. To make the most of the connect
copy function, it is advisable that you make the same paper settings on both the main and sub-
machines.
Paper Type: Tray 1 (with the optional A3/11×17 Tray Unit)
• The main and sub-machines follow their respective set values.
• In connect copy, only the paper tray corresponding to the paper size, orientation, and type that
are set in common on the main and sub-machines can be used. To make the most of the connect
copy function, it is advisable that you make the same paper settings on both the main and sub-
machines.
Paper Type: Tray 2
• The main and sub-machines follow their respective set values.
• In connect copy, only the paper tray corresponding to the paper size, orientation, and type that
are set in common on the main and sub-machines can be used. To make the most of the connect
copy function, it is advisable that you make the same paper settings on both the main and sub-
machines.
Paper Type: Tray 3
• The main and sub-machines follow their respective set values.
2. Tray Paper Settings
98
2