The default setting is [Normal].
Key Repeat
You can enable or disable repetition of an operation if a key on the screen or control panel is pressed
continuously.
The keys affected by the key repeat setting can vary depending on the selected function.
The default setting is [Normal].
Z-fold Position
You can adjust the position of the lines of the Z-fold in steps of 1 mm.
Paper size Setting ranges Factory-set values
A3 2 – 25 mm
(0.1 in. – 1.0 in.)
2 mm (0.1 in.)
11 × 17 2 – 20 mm
(0.1 in. – 0.8 in.)
B4JIS, A4, 8
1
/
2
× 14, 8
1
/
2
×
11, Others
2 – 17 mm
(0.1 in. – 0.7 in.)
Half Fold Position
You can adjust the position of the lines of the half fold in steps of 1 mm.
Paper size Setting ranges Factory-set values
A3, B4JIS, A4, 11 × 17,
8
1
/
2
× 14, 8
1
/
2
× 11, Others
-10 – 10 mm
(-0.4 – 0.4 in.)
0 mm (0 in.)
Letter Fold-out Position
You can adjust the position of the lines of the letter fold-out in steps of 1 mm.
When you specify multifold, you cannot change the positions of the folds. Any adjusted settings will
be cleared if you press [OK] when prompted to select multifold.
Paper size Setting ranges Factory-set values
A3, B4JIS, A4, 11 × 17,
8
1
/
2
× 14, 8
1
/
2
× 11, Others
-10 – 10 mm
(-0.4 – 0.4 in.)
4 mm (0.2 in.)
Letter Fold-in Position
You can adjust the position of the lines of the letter fold-in in steps of 1 mm.
1. System Settings
22
To Next Page
Loading...
