• Password
• Realm Name
• Search Conditions
• Search Options
To start a LDAP search, make sure that the items listed below are set. For other items, check your
environment and make any necessary changes.
This function supports LDAP Version 2.0 and 3.0.
To use the LDAP server, select [On] under LDAP Search.
For details about how to program the LDAP Server, see "Programming the LDAP server".
LDAP Search
You can specify whether or not to use the LDAP server for searching.
The default setting is [Off].
If you select [Off], LDAP server list will not appear on the searching display.
Program / Change / Delete Realm
You can program the realm to be used for Kerberos authentication.
• Realm Name
• KDC Server Name
• Domain Name
Be sure to set both the realm name and KDC server name when programming a realm.
For details about Program/Change/Delete Realm, see "Programming the Realm".
AOF (Always On)
You can specify whether or not to use Auto Off.
The default setting is [On].
Service Mode Lock
For details about this function, consult your administrator.
Firmware Version
You can check the version of the software installed in this machine.
Network Security Level
For details about this function, consult your administrator.
Auto Erase Memory Setting
For details about this function, consult your administrator.
Erase All Memory
For details about this function, consult your administrator.
1. System Settings
50
To Next Page
Loading...
