Toshiba GX9 - Page 102

90 GX9 ASD Installation and Operation Manual
Input Terminal 5 (S1) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S1 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S1 terminal to one of the user-selectable
functions listed in Table 8 on pg. 217.
Direct Access Number — F115
Parameter Type — Selection List
Factory Default — Preset Speed 1
Changeable During Run — No
Input Terminal 6 (S2) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S2 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S2 terminal to one of the user-selectable
functions listed in Table 8 on pg. 217.
Direct Access Number — F116
Parameter Type — Selection List
Factory Default — Preset Speed 2
Changeable During Run — No
Input Terminal 7 (S3) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S3 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S3 terminal to one of the user-selectable
functions listed in Table 8 on pg. 217.
Direct Access Number — F117
Parameter Type — Selection List
Factory Default — Preset Speed 3
Changeable During Run — No
Input Terminal 8 (S4) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the S4 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S4 terminal to one of the user-selectable
functions listed in Table 8 on pg. 217.
Direct Access Number — F118
Parameter Type — Selection List
Factory Default — Emergency Off
Changeable During Run — No
Input Terminal 9 (LI1) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI1 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI1 terminal to one of
the user-selectable functions listed in Table 8 on pg. 217.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (D/N 58685) for
more information on the function of this terminal.
Direct Access Number — F119
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F115 F119