GX9 ASD Installation and Operation Manual 111
RR Reference Point 2
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR terminal when the RR
terminal is used as the control input while operating in the Speed Control
mode or the Torque Control mode.
This parameter sets the RR level that is associated with RR Input Point 2
Frequency when operating in the Speed control mode or is associated with the
RR Input Point 1 Torque when operating in the Torque Control mode.
This value is entered as 0% to 100% of the RR signal range.
See RR Reference Point 1 (F210) for more information on this setting when
used for Speed control.
See RR Input Point 1 Torque (F214) for more information on this setting
when used for Torque Control.
Direct Access Number — F212
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 100.00
Units — %
RR Input Point 2 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR terminal when the RR
terminal is used as the control input while operating in the Speed Control
mode.
This parameter sets RR Input Point 2 Frequency and is the frequency that is
associated with the setting of RR Reference Point 2 when operating in the
Speed Control mode.
See RR Reference Point 1 (F210) for more information on this setting.
Direct Access Number — F213
Parameter Type — Numerical
Factory Default — 80.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq. (F011)
Units — Hz
F212 F213
To Next Page
Loading...
Need help?
General
