GX9 ASD Installation and Operation Manual 119
RX2 Input Point 2 Torque
Program Torque Setpoints
This parameter is used to set the gain and bias of the RX2 terminal when the
RX2 terminal is used as the control input while operating in the Torque
Control mode.
Torque Control is accomplished by establishing an associated V/f output
pattern for a given RX2 level.
This parameter sets RX2 Input Point 2 Torque and is the output torque value
that is associated with the setting of RX2 Reference Point 2 when operating in
the Torque Control mode.
This value is entered as -250% to +250% of the rated torque.
See RX2 Input Point 1 Torque (F226) for more information on this setting.
Direct Access Number — F227
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — -250.00
Maximum — +250.00
Units — %
F227 F227
To Next Page
Loading...
