GX9 ASD Installation and Operation Manual 175
Pattern Run Group 3 Selection 6
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 6 selection to be included in the Group 3 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F556
Parameter Type — Selection List
Factory Default — Preset Speed 6
Changeable During Run — No
Pattern Run Group 3 Selection 7
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 7 selection to be included in the Group 3 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F557
Parameter Type — Selection List
Factory Default — Preset Speed 7
Changeable During Run — No
Pattern Run Group 3 Selection 8
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 8 selection to be included in the Group 3 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F558
Parameter Type — Selection List
Factory Default — Preset Speed 8
Changeable During Run — No
Pattern Run Group 4 Repeat Factor
Program Frequency Pattern Run
This parameter sets the number of times that the pattern defined in Group 4
will be run.
Direct Access Number — F560
Parameter Type — Numerical
Factory Default — 1
Changeable During Run — No
Minimum — 1
Maximum — 255 (Infinite)
Units — Repetitions
Pattern Run Group 4 Selection 1
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 1 selection to be included in the Group 4 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F561
Parameter Type — Selection List
Factory Default — Preset Speed 9
Changeable During Run — No
F556 F561
To Next Page
Loading...
