6F8C1497
xii
Introduction
This hardware instruction manual is provided for T series migration to upgrade the system of T series
programmable controller PROSEC, T2/T3 series (T2/T2E/T2N and T3/T3H/T3V) and T series
compatible controller S2E/S2T to the system of unified controllers, type1 light PUM11 andPUM12.
The product specifications of the controllers subject to the T series migration are listed in this manual.
Please refer to the relevant instruction manuals for the specification of existing T2/T3 series, S2E/S2T
and type1 light models.
For the conversion of system data, generated with T-PDS on T2/T3 series and S2E/S2T controllers to
the system data for type1 light PUM11/PUM12 controllers, use “T-PDS conversion tool” stored in the
install folder of unified controller nv series/integrated controller V series engineering too 4 (nV- Tool4,
hereafter referred to as “engineering tool” or nv-TOOL”). For details of T-PDS conversion tool, refer to
“type1 light T series Migration Guide (6F8C1497).
Engineering tool name Usage
Client Server version nV-Tool 4
For unified controller nv series
controllers
Standalone version nV-Tool 4
The support versions are shown below. Be sure to check the version/serial number before using them.
Name Version
nV-Tool 4 V4.11.18 and later
type1 light PUM11/PUM12 V01.40 and later
Name Version
G2 I/O adapter GA922 xx1331 and later*1
*1 The serial number is indicated on the side of the product.
xx is a 2-digit alphanumeric character. Check the subsequent 4-digit number.
※１：開発中
To Next Page
Loading...
