Toshiba nv Series - A.2 Outline Drawing

Unified Controller nv Series type1 light Controller Unit Operating Instructions
123
A
A.2 Outline Drawing
The external views of base unit BUM7B dedicated to the migration system are shown
below.
External dimensions
Figure A.2 External dimension of BUM7B
Be sure to mount the terminal block signal conversion adapter or attached blank panel
on slots S1, S6 and S11.
BUM7B may deform or break if it is transported, installed or operated without anything
inserted in these slots.
When handling BUM7B, wear protective gloves to prevent injury caused by the metal
frame edge or sharp parts of BUM7B.
Top view
左側面
Front view
480mm
200mm
160mm
167.5m
465mm
250mm
Power input terminal block
Blanc panel
Power connector cover
Left side view
LED (POWER)
Top bracket
Mounting hole x 4
G2 I/O module mounting hole x 11
Terminal block signal conversion adapter
mounting hole
(Top bracket (11) + Bottom bracket (11))
Bottom bracket