Toshiba nv Series - Base Unit

Chapter 1 Overview of T Series Migration
6F8C1497
8
1.4.2 Base Unit
There are two types of base unit applicable to the T series migration system:
Standard base unit for unified controller type1 light
Base unit for T series migration systems
The modules are inserted into the mountable slots of the base unit. The slots which are
not specified as mountable cannot be used. Be sure to mount the modules into the
specified slots.
(1) Standard base unit for unified controller type1 light
Refer to “Unified controller nv series type 1 light Controller Unit User’s Manual - Basic Hardware -”
(6F8C1497) for the appearance and specification of the standard base unit.
The standard base unit for unified controller type1 light is used as:
Main base unit (for mounting the controller module)
Expansion base unit (connected with the expansion interface module)
Remote station main base unit (for mounting the G2 I/O adapter module)
Table 1.5 Mounting slots on the main base unit
Slot
Base unit PIF PS S0 S1 S2 S3 S4 S5 S6 S7 S8
BU648E - - PUM12 ALL ALL ALL ALL IO IO IO IO
BU643D - - PUM12 ALL ALL ALL
BU668 - - PUM11 IO IO IO IO IO IO IO IO
BU666 - - PUM11 IO IO IO IO IO
BU664 - - PUM11 IO IO IO
PIF: For mounting the expansion interface module (IF661)
PS: For mounting the power supply module (PS693, PS632, PS652)
S0 - S8: For mounting modules
PUM12: For mounting PUM12
PUM11: For mounting PUM11
I/O: For mounting the G2 I/O module
ALL: For mounting station bus module or G2 I/O module
◆ Remark
Be sure to install an empty module (SP600) or IF cover (SP601) for the slot which
does not contain a module.