Toshiba nv Series - D.1 Migration Method

Unified Controller nv Series type1 light Controller Unit Operating Instructions
125
A
The association between the mounting holes for the top bracket of base unit BUM7B
dedicated to the migration system and those for G2 I/O module is shown below.
Insert a 150mm or longer Phillips screwdriver into the G2 I/O module mounting hole on
the top bracket to tighten or loosen the screw securing the G2 I/O module (tightening
torque: 1.47N･m).
Figure A.4 BUM7B’s G2 I/O module mounting holes and screwdriver insertion
Top bracket mounting plane
Top bracket front view
Module mounting base panel
G2 I/O module mounting hole x 7
S2, S3, S5, S6, S7, S9, S10
Common to top bracket mounting
G2 I/O module mounting hole x 4
S1, S4, S8, S11
Top bracket mounting hole x 4
G2 I/O module mounting hole x 11
[
S1
]
[
S2
]
[
S3
]
[
S4
]
[
S5
]
[
S6
]
[
S7
]
[
S8
]
[
S9
]
[
S10
]
[
S11
]
Insert the screwdriver in S5