Toshiba nv Series - Page 170

Unified Controller nv Series type1 light Controller Unit Operating Instructions
151
B
B.3.5 EXM35
EXM35: DA364→DA664 (for G3 I/O migration) terminal block signal conversion adapter
DA364 terminal
block
DA664 terminal
block
DA364 terminal
block
DA664 terminal
block
Pin No.
Terminal
name
Terminal
name
Pin No. Pin No.
Terminal
name
Terminal
name
Pin No.
1 ADJ -
2 ADJ -
3 1P - 1V_P 1 1C_P 3
4 1N - 1V_N 2 1C_N 4
5 1G - 20
6 1P - 2V_P 5 2C_P 7
7 1N - 2V_N 6 2C_N 8
8 1G - 20
9 1P - 3V_P 9 3C_P 11
10 1N - 3V_N 10 3C_N 12
11 1G - 20
12 1P - 4V_P 13 4C_P 15
13 1N - 4V_N 14 4C_N 16
14 1G - 20
15 24Vdc+ - 24Vdc+ 17
16 24Vdc- - 24Vdc- 18
17 HG - HG 19
18 FG - FG 20
19 ALARM
20 ALARM
The connection of pins 1 and 2 of the DA364 terminal block differs when EXM35 is mounted as
shown in the table below.
Pin No. When EXM35 is mounted: When DA364 is mounted:
1 NC Unconnected
Normally open (analog output)
2 NC Unconnected
Pins 19 and 20 (alarm output) of the DA364 terminal block do not function when EXM35 is
mounted.
The current output terminals (nC_P, nC_N) of DA664 cannot be used when EXM35 is mounted.
Figure B.15 EXM35 signal conversion
1V__P
1I_P
2V_P
2I_P
3V_P
3I_P
4V_P
4I_P
24Vdc+
LG
1V_N
1I_N
2V_N
2I_N
3V_N
3I_N
4V_N
4I_N
24Vdc
-
FG
CBM35 (terminal block type)