Toshiba Qosmio F60 Series

エラー ! スタイルが定義されていません。 Replacement Procedures エラー !
ス
4-56 [CONFIDENTIAL] QOSMIO F60 Maintenance Manual (960-796)
Installing the RGB harness
To install the RGB harness, follow the steps below and refer to Figure 4-32 and 4-33.
1. Set the RGB harness into the guides of the brake hinge LOW L.
2. Arrange the RGB harness along the guides of the brake hinge LOW L.
3. Set the brake hinge LOW L (with the RGB harness) in place and secure it with the
following screw.
 M2.56B FLAT HEAD screw 1
 M2.56C Tapping screw 1
4. Connect the RGB harness to the connector CN9510 on the system board.