–27–
Installation Manual
Manually inputting model names and serial numbers
1 In the “Register service info.” screen, press
[ ] and [ ] to select “Outdoor model
name”, and then press [ Set/Fix]
For the serial number of outdoor units, select
“Outdoor serial No.”.
For the model name of indoor units, select “Indoor
model name”.
For the serial number of indoor units, select “Indoor
unit serial No.”.
2 In the “Outdoor model name” screen, press
[ ] and [ ] to select “Manual model
name input”, and then press [ Set/Fix]
For the serial number of outdoor units, select “Manual
serial No. input”.
For the model name of indoor units, select “Manual
model name input”.
For the serial number of indoor units, select “Manual
serial No. input”.
3 Inputting outdoor unit model names
For the input method, refer to <Name of room (Set
the name of the location that the remote controller is
installed)>. (Page 14)
4 By selecting “remote controller” in “Model
name selection”, the manually input model
name and serial number are displayed
(Page 28)
Shows the address of the selected system of indoor units.
To Next Page
Loading...
