To Next Page

To Previous Page

– 56 –

INTERFACE MANUAL

STE 85457

EXTERNAL SELECT FILE

*** [ 00 - 0F ] *****

= "PROG00"

= "PROG01"

= "PROG02"

= "PROG03"

= "PROG04"

= "PROG05"

= "PROG06"

= "PROG07"

= "PROG08"

= "PROG09"

= "PROG0A"

= "PROG0B"

= "PROG0C"

= "PROG0D"

= "PROG0E"

= "PROG0F"

The initial setting is as shown above. Specify a file name you registered

beforehand for the underlined of "PROG**".

Example:

[U08] EXTSELECT file

= "AAA"

= "BBB"

= "CCC"

= "DDD"

Specify the above program names in advance. Then specify zero (0) for both bits 1

and 2 of DIN command, which are set under [U07] (assume that [U07] = 1 2) and

input the STROBE signal. Program "AAA" is automatically selected now. (If the

following steps are taken without registering the program names, a "Compile Error"

occurs.)

After the above parameter has been changed, save the data, turn the power off and

on again. Otherwise, the parameter will not be operative.

Toshiba TSL3000E Series Interface Manual

Other manuals for Toshiba TSL3000E Series