EasyManua.ls Logo

Toyota 4Runner - Before Towing; Break-In Schedule; Service Connector for Towing Brake Controller

Toyota 4Runner
655 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
289
2-5. Driving information
2
When driving
4RUNNER_U
n Service connector for towing brake controller
n Before towing
Check that the following conditions are met:
l The vehicle’s tires are properly inflated.
l Trailer tires are inflated according to the trailer manufacturer’s recom-
mendation.
l All trailer lights work.
l All lights work each time you connect them.
l The trailer ball is set up at the proper height for the coupler on the trailer.
l The vehicle remains level when a loaded or unloaded trailer is hitched.
Do not drive if the vehicle is not level, and check for improper tongue
load, overloading, worn suspension, or other possible causes.
l The trailer cargo is securely loaded.
l The rear view mirrors conform to all applicable federal, state/provincial or
local regulations. If they do not, install rear view mirrors appropriate for
towing purposes.
n Break-in schedule
If your vehicle is new or equipped with any new power train components
(such as an engine, transmission, differential and wheel bearing), Toyota
recommends that you do not tow a trailer until it has been driven for over 500
miles (800 km).
However, avoid full throttle acceleration.
Your vehicle is equipped with a service
connector for the trailer brake controller
as shown.
CTH25AS008

Table of Contents

Other manuals for Toyota 4Runner

Related product manuals