464
3-7. Other interior features
4RUNNER_U
Test the HomeLink
®
operation
by pressing the newly pro-
grammed button.
If a HomeLink
®
button has been
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
garage transmitter is of the rolling
code type. Press and hold the
programmed HomeLink
®
button.
The remote control transmitter is
of the rolling code type if the
HomeLink
®
indicator light flashes
rapidly for 2 seconds and then
remains lit. If your transmitter is
the rolling code type, proceed to
the heading “Programming a roll-
ing code system”.
Repeat the steps above to program another device for any of
the remaining HomeLink
®
buttons.
STEP
3
STEP
4
To Next Page
Loading...
